Punto Plast Hot Stapler Instructions

Plug in the control box and turn on. Carefully insert desired staple into one of the three possible positions in the end of the stapler without depressing the power button on the handle. Once pressed to the bottom of the hole, the unit is ready for use.

3 different staple positions

Setting the temperature:

Turn the control dial to the second or third position (unless very low heat levels are desired.) These two positions satisfy most stapling applications.

Use:

Lay staple over desired location and apply gentle pressure. Push the button on the handle, then release once the staple is at the desired depth. Allow to cool slightly. Pull back and the staple will remain in the plastic. Clip off the staple with a diagonal cutter.