Urethane Supply Company
Plastic Repair Gurus
since 1981

Welcome! Sign in or register.   Forgot password

How to Restore an ABS Plastic Grille

When restoring older cars, it is often too expensive to replace a broken grille. And, that is assuming a new grille is available. In cases where new parts are too expensive, too difficult to find, or, impossible to find, you will need to restore what is already there. The ABS Grille on this 1971 Oldsmobile Vista Cruiser is a good example. It has cracks and missing pieces.

zoom in

Step 1

This grill has cracks and missing pieces. This "How-To" will just show how to create the missing piece.

cracked ABS grille
zoom in

Step 2

Drop the molding bars into boiling water. Heat the water in the microwave. It takes just a few minutes. Allow enough time for the heat to soften the molding bars all the way through and remove the molding bars from the boiling water. They will be soft and pliable for a short time.

Vista Cruiser Grille
zoom in

Step 3

While the molding bars are still soft, press them onto an existing part to create a negative. Hold it in place until the molding bar cools off. This will be the pattern that you will use to create the missing piece.

moulding bar
zoom in

Step 4

Tape the molding bar into place. This particular piece has a curve and we didn’t have a curved section to make a pattern with, so we used aluminum tape to create a pattern for the curved part.

dash pad repair
zoom in

Step 5

Squeeze 2 or 3 drops of liquid onto the powder then use the tip of the needle to stab the ball of liquid and powder. The hole of the needle is on the side of the needle; not at the tip. When you transfer the ball of liquid and powder to the pattern, give the bottle another squeeze. The liquid will run down the side of the needle and wash off the ball. Continue using this method until the mold is filled with PlastiFix.

zoom in

Step 6

Another technique to apply Plastifix is to sprinkle a thin layer of powder, then saturate the powder with drops of liquid. Keep adding layers until you get the desired thickness.

On more thing… this technique works best on horizontal surfaces.

Apply PlastiFix
zoom in

Step 7

Allow time for the PlastiFix to cure fully before removing the tape and molding bar.

repair grille
zoom in

Step 8

Allow time for the Padded Dash Filler to cure. Sand it smooth starting with 180 grit sandpaper and then 320 grit sand paper.

repair cracked dash
zoom in

Step 9

It looks pretty rough right now.

restore ABS grille
zoom in

Step 10

Use a rotary tool or sand paper to get the cured plastifix to the right shape.

dash cap
zoom in

Step 11

Mix a small amount of Putty Flex with cream hardener on a mixing board and apply the Putty Flex the best that you can with a spreader. In the curved area, it is easier to apply it with your finger.

zoom in

Step 12

Sand the Putty flex with 180 grit sand paper and finish sanding it with 320 grit sand paper to get it really smooth.

Putty Flex
zoom in

Step 13

Apply primer to the grille and it will be ready to paint.

All Seasons
zoom in

Step 14

As you can see, the grille looks great. Now, for the rest of the car. Sad face

grille restoration
zoom in


Vista Cruiser Grille
zoom in

Products Used For This Repair

PlastiFix Kit (White)
$ 35.95
Putty Flex w/ cream hardener
$ 36.95
All Seasons Light Gray E-Z Sand, Quart
$ 32.95